Skip to Content
PCAN-USB Pro FD
v3.5.3
3.4.7 18/04/2024
Bug fixes
- SOF and OUT-NACK IRQs disabled due to IRQ flooding on OUT-PINGs
- 2nd device ID was not returned by vendor request (available on Linux)
3.4.4 28/03/2022
Changes
- CAN Core updated
- Option added: Send ACK as transmitter
- Option added: Generate time stamp at start of frame
- Option added: Ignore BRS frames as receiver
- LIN commands improvements
- LIN Wake-Up was not working after LIN power cycles
- Bugfix: Status Frame suppressed when leaving reset mode during BusOff
- Internal Firmware improvements
3.2.0 31/08/2017
Changes
- Bugfix for CAN bitrate prescaler
- Mode added to force CAN 2.0 A/B
- Timestamps for RCV frames at bit 6 of end-of-frame
3.1.1
Changes
- Bugfix CAN core, bad TX data due to RAM pointer increment
- TX pause added for transmit delay
3.1.0
Changes
- Bugfix CAN core, bad TX data due to RAM pointer reset
3.0.0
Changes
- New CAN core Gen 3 included (new implementation of BSP/BTL, tested with Bosch Ref CAN model)
2.3.1
Changes
- Bugfix/modification for timestamp system (CAN/LIN with offset)
2.3.0
Changes
- Firmware version change for USB MSD bootloader
2.2.1
Changes
- Bugfix: bad frames in CAN FD ISO mode with DLC=0
2.2.0
Changes
- Bugfix "error frames in listen-only mode"
- USB descriptor for LIN endpoints modified
- USB "other descriptor" modified
2.1.0
Changes
- USB suspend modification
- Fast-forward option added
2.0.3
Changes
- Flash mode depends on password
- LED toggle for locked CAN
2.0.0
Changes
- CAN core with ISO/Non-ISO support
- OEM area added (OEM_CODE, password ...)
1.1.6
Changes
- Modification for USB packet sizes of LIN endpoints (limited FIFO size of USB controller, data corruption on parallel CAN/LIN communication)
1.1.5
Changes
- FPGA modification for I/O signaling
Neutralized
