2.3.1 04/02/2020

Improvements

• Added support for new hardware PCAN-Router Pro FDPlease note:The support was dropped for PCAN-Router Pro FD with a bootloader version from 2.0.0. PEAK-Flash should be used for firmware uploads instead.

2.3.0 09/10/2018

Improvements

• Added support for device PCAN_LAN to flash hardware over PCAN-Gateways
• Date fields in the detect response are tested for valid value ranges
• Better protection against transferring a firmware to an incomatible hardware
• Added support for upcoming hardware PCAN-MicroMod FD and PCAN-MiniDiag FD

Changes

• Parameters of hardware profiles are locked against changes in the user interface by default

2.2.2 30/06/2017

Improvements

• Better detection that the flash target matches the selected firmware file

Changes

• For safety reasons, it is no longer possible to change parameters of hardware profiles in the Options dialog box

2.2.1 30/08/2016

Changes

• Bug fix: While transferring data to a hardware module, under certain circumstances one byte of data was omitted in the last data block

2.2.0 26/04/2016

Bug fixes

• When the parameter "Upload address" was set to "from Bin-File" in the Hardware Profile, a memory exception could occur during the flash process
• Flashing a module after activating it in the list was not possible sometimes

Changes

• Some internal optimizations

2.1.1 23/11/2015

Bug fixes

• While connecting with a PCAN hardware an error message could be displayed, which warned that the hardware is already in use (HWINUSE)

Changes

• Added the PCAN-Router FD, PCAN-USB FD, and PCAN-USB Pro FD in the list of products which firmware can be updated with this software
• Updated the PCAN-Flash documentation