Open Linux IoT Gateway Cortex A8
Operation on trucks, buses and trains. Remote download of the digital tachograph, DTCO. Vehicle fleet management. Operating data logging. Smart metering. Condition and remote monitoring. Connected car.
High-performance Linux IoT gateway, with worldwide LTE Cat 4, for processing data from wired and wireless sensors, devices and peripherals. The owa4X is placed as close as possible to your equipment to monitor and control it, sending only relevant information to cloud services or your own custom control center.
Key points
- IP67 -
- Dust-tight and protected against temporary immersion
- Worldwide LTE Cat 4: 4G worldwide with 3G/2G fallback
- ARM Cortex A8 32bit 800MHz
- 512MB DDR3 (Up to 1 GB)
- 1GB NAND Flash (Up to 2 GB)
- Running LINUX OS
- Debian file system
- Highly customizable and powerful, like any Linux system. Programmable in C, Python...
- Simultaneous reception of up to 3 GNSS
- GPS, GLONASS, GALILEO, BeiDou
- Programmable 9-axis sensor:
- Accelerometer /
- Gyroscope /
- Magnetometer.
- Optional Dead Reckoning
- WiFi 802.11 a/b/g/n/ac
- Bluetooth 4.2
- Wide choice of interfaces:
- Up to 4 CAN buses (full speed 1Mbps CAN 2.0B)
- Up to 2 K-line buses
- Digital and analog I/O
- 3x RS232 and 1x RS485
- USB Host 2.0
- Ethernet, Maxim 1-wire, uSD card slot, audio codec...
- Power-saving modes and Li-Ion backup battery
Processor
- ARM Cortex A8 at 800 MHz clock frequency.
- Debian distribution file system*
- NAND FLASH 1 GB (up to 2 GB)
- DDR3 512 MB (up to 1 GB)
- MicroSD card slot for additional storage.
GNSS
- Receiver: GPS/GLONASS/QZSS/BeiDou.
- 72-channel continuous tracking receiver*.
- GALILEO E1B/C compatible. *
- SBAS: WAAS, EGNOS, MSAS, GAGAN.
- Update rate: 10 Hz.
- Accuracy: 2 meters CEP.
- Signal acquisition:
- Cold start: 26 s.
- Warm start: < 1,5 s.
- Signal re-acquisition: < 1 s.
- Active antenna power supply: +3.0 V @ 34 mA.. *
- Feature availability depends on version.
Interfaces
- Up to 4 CAN buses
- 2 CAN buses supporting a maximum rate of 1 Mbps CAN 2.0B.
- 2 CAN FD supporting 8 Mbps. (Global LTE option only)
- Up to 2 K-line buses.
- Built-in sensors:
- Programmable 9-axis sensor (accelerometer, gyroscope and magnetometer).
- TPM 2.0 (Global LTE option only)
- 10 configurable digital inputs/outputs:
- Inputs 50 V max. (low logic level 3 V).
- All inputs act as wake-up signals for low-power modes.
- All inputs can be used as counters (odometer). 32-bit, 3 kHz max.
- 8 open-collector outputs (200 mA each).
- 2 high-side switches to Vin for output (1 A each).
- Short-circuit protection for all outputs.
- 4 analog inputs:
- 12-bit resolution, 1% accuracy.
- 1 sharing digital I/O pins and 3 dedicated pins.
- 0-5.12 V (5 mV per bit) or 0-30.72 V (30 mV per bit) software configurable
- Maxim 1-wire
- microSD card slot.
- USB Host 2.0.
- 3 external RS232 ports. 6 pins software-configurable as follows:
- 3 x (TX/RX) or
- 1 x (TX/RX) & 1 x (TX/RX/CTS/RTS) or
- 1 x (TX/RX/CTS/RTS/DCD/DTR)
- One RS485 port.
- Ethernet 10/100 Base-TX
- Vout 5 V power output (500 mA max.).
- FAKRA antenna connectors.
- 4 status indicator LEDs.
- Audio CODEC for external microphone and speaker.
- Feature availability depends on model.
Power supply
- Nominal range from 9 V to 36 V
- Typical consumption at 24 V
Batteries
- Backup when no power supply is available.
- Standard backup battery for RTC. 10-year life.
- Optional 3.7 V Li-Ion rechargeable battery. Inserted via the rear battery cover
Temperature
- Industrial temperature range components -40 °C to 85 °C
LTE Cat 4 / 3G / 2G
- LTE FDD B1/B2/B3/B4/B5/B7/B8/B12/B13/B18/B19/B20/ B25/B26/B28
- LTE TDD B38/B39/B40/B41
- UMTS B1/B2/B4/B5/B6/B8/B19
- GSM 850/900/1800/1900 MHz
- LTE-FDD: 150 Mbps max. (DL), 50 Mbps max. (UL)
- LTE-TDD: 130 Mbps max. (DL), 30 Mbps max. (UL)
- Rugged housing
- IP67 environmental protection
- (total protection against dust and water)
- Dimensions: L=149 x W=135 x H=58 mm
- Weight: 385 g
- Material: fiberglass-reinforced polyester
- System connectors: TE 776163-1 (35 pins)
- MicroSIM
- MicroSD
Open Linux IoT Gateway Cortex A8
Operation on trucks, buses and trains. Remote download of the digital tachograph, DTCO. Vehicle fleet management. Operating data logging. Smart metering. Condition and remote monitoring. Connected car.
High-performance Linux IoT gateway, with worldwide LTE Cat 4, for processing data from wired and wireless sensors, devices and peripherals. The owa4X is placed as close as possible to your equipment to monitor and control it, sending only relevant information to cloud services or your own custom control center.
Key points
- IP67 -
- Dust-tight and protected against temporary immersion
- Worldwide LTE Cat 4: 4G worldwide with 3G/2G fallback
- ARM Cortex A8 32bit 800MHz
- 512MB DDR3 (Up to 1 GB)
- 1GB NAND Flash (Up to 2 GB)
- Running LINUX OS
- Debian file system
- Highly customizable and powerful, like any Linux system. Programmable in C, Python...
- Simultaneous reception of up to 3 GNSS
- GPS, GLONASS, GALILEO, BeiDou
- Programmable 9-axis sensor:
- Accelerometer /
- Gyroscope /
- Magnetometer.
- Optional Dead Reckoning
- WiFi 802.11 a/b/g/n/ac
- Bluetooth 4.2
- Wide choice of interfaces:
- Up to 4 CAN buses (full speed 1Mbps CAN 2.0B)
- Up to 2 K-line buses
- Digital and analog I/O
- 3x RS232 and 1x RS485
- USB Host 2.0
- Ethernet, Maxim 1-wire, uSD card slot, audio codec...
- Power-saving modes and Li-Ion backup battery
