Interconnection module with alternative CAN transceivers
The PCAN-AU5790 bus converter provides a gateway between a high-speed CAN network (ISO 11898-2) and a single wire CAN bus (SAE J2411). One of its common uses is the simplified connection of a CAN interface from the PCAN range (for example PCAN-USB) to a single wire CAN bus.
D-Sub Socket Pinout
| 1 | 5V Power supply |
| 2 | CAN-L |
| 3 | GND |
| 6 | GND |
| 7 | CAN-H |
| 9 | Not connected / Optional +5V |
D-Sub Connector Pinout
| 3 | GND |
| 5 | CAN |
| 6 | GND |
| 9 | VBAT |
- Ability to configure three different CAN operating modes via slide switch on the software side. Normal mode (33.3 kbit/s), high-speed (83.3 kbit/s) and wake-up
- Power supply (red) and wake-up signal (yellow) indicator LEDs
- Power supply (5 V, 150 mA) via HS-CAN connection (a current list of PEAK-CAN interfaces with adequate power supply can be provided on request)
- For a power supply with a current rating below 150 mA, an additional 12-volt supply via the SW-CAN connector is required.
- Operating temperature range from 0 to 70 °C
- Adapter in plastic housing
- Manual in PDF format
Manual PCAN-AU5790
Interconnection module with alternative CAN transceivers
The PCAN-AU5790 bus converter provides a gateway between a high-speed CAN network (ISO 11898-2) and a single wire CAN bus (SAE J2411). One of its common uses is the simplified connection of a CAN interface from the PCAN range (for example PCAN-USB) to a single wire CAN bus.
D-Sub Socket Pinout
| 1 | 5V Power supply |
| 2 | CAN-L |
| 3 | GND |
| 6 | GND |
| 7 | CAN-H |
| 9 | Not connected / Optional +5V |
D-Sub Connector Pinout
| 3 | GND |
| 5 | CAN |
| 6 | GND |
| 9 | VBAT |
