Wiring harness dedicated to the PCAN-USB Pro FD and PLIN-USB interfaces
The PLIN-USB connects to the LIN bus via a D-Sub connector. The PCAN-USB Pro FD and PCAN-USB Pro interfaces, for their part, combine the CAN and LIN buses on the same D-Sub connector. However, separate access to the LIN part is essential for some applications.
This LIN connection cable makes it possible to probe each line individually. The LIN signals and the power lines are routed to separate plugs, while the CAN lines are routed back to a D-Sub connector.
This cable is fully compatible with CAN FD buses.
Note
The LIN connection cable for PC-LIN interfaces is not suitable for use with the PCAN-LIN.
- Pre-configured cable set for PCAN-USB Pro FD, PCAN-USB Pro and PLIN-USB
- Separation of the CAN/LIN connector lines for: CAN (9-pin D-Sub plug) LIN (4 mm banana plug) LIN power supply (4 mm banana plugs)
- CAN (9-pin D-Sub plug)
- LIN (4 mm banana plug)
- LIN power supply (4 mm banana plugs)
- Without termination resistor
- Length 0.75 m
- Compatible with CAN-FD buses
- LIN connection cable for PC LIN interfaces
Wiring harness dedicated to the PCAN-USB Pro FD and PLIN-USB interfaces
The PLIN-USB connects to the LIN bus via a D-Sub connector. The PCAN-USB Pro FD and PCAN-USB Pro interfaces, for their part, combine the CAN and LIN buses on the same D-Sub connector. However, separate access to the LIN part is essential for some applications.
This LIN connection cable makes it possible to probe each line individually. The LIN signals and the power lines are routed to separate plugs, while the CAN lines are routed back to a D-Sub connector.
This cable is fully compatible with CAN FD buses.
Note
The LIN connection cable for PC-LIN interfaces is not suitable for use with the PCAN-LIN.
