CAN and CAN FD cable for test and measurement benches
This cable allows the two components CAN_L and CAN_H of the differential CAN signal to be tapped directly from the bus or from a CAN interface. Banana plugs make it easy to connect to test and measurement equipment. The PCAN-Cable 3 is also compatible with CAN FD buses.
Note: a slightly revised version of this cable has been marketed since the end of 2023.
- One 9-pin D-Sub connector (compliant with CiA® 106) with 4 mm banana plugs to tap the CAN_L and CAN_H signals
- Without terminating resistor
- Length 2.0 m
- Compatible with CAN FD buses
- PCAN-Cable 3
CAN and CAN FD cable for test and measurement benches
This cable allows the two components CAN_L and CAN_H of the differential CAN signal to be tapped directly from the bus or from a CAN interface. Banana plugs make it easy to connect to test and measurement equipment. The PCAN-Cable 3 is also compatible with CAN FD buses.
Note: a slightly revised version of this cable has been marketed since the end of 2023.
